2018 Can-am Spyder F3
Problems, recalls and owner-reported issues
Power train is the leading concern among 12 owner complaints filed for this model year. This is the highest complaint count among 10 Spyder F3 model years with reports.
What owners report most often
Recalls and investigations
Power train, manual transmission, internal, shaft, outputOct 1, 2024
Bombardier Recreational Products (BRP) is recalling certain 2017-2019 Can-Am Spyder F3 and RT motorcycles. The engine output shaft may fatigue and break, resulting in a loss of drive power.
A loss of drive power increases the risk of a crash.
The output shaft will be replaced based on the mileage of the vehicles. Owner notification letters were mailed February 5, 2025. Owners may contact BRP customer service at 1-888-272-9222.
Campaign 24V728000 on NHTSA.gov
Power train, manual transmissionMay 18, 2022
Bombardier Recreational Products, Inc. (BRP) is recalling certain 2015-2019 Can-Am Spyder F3 and RT motorcycles. The front sprocket may be defective and prematurely wear, resulting in a loss of drive power.
A loss of drive power increases the risk of a crash.
Dealers will perform an interim repair until parts become available. Once parts are available, the front sprocket will be replaced, free of charge. Owner notification letters were mailed May 26, 2022. Owners may contact BRP customer service at 1-888-272-9222.
Campaign 22V352000 on NHTSA.gov
Representative owner complaints: fuel/propulsion system
1 report, newest first. Show all
Vehicle speed control, Engine, Fuel/propulsion system, Jun 17, 2024
While driving on a straight stretch of highway at posted highway speeds of 75mph, no additional acceleration, torque, turning, or high rpms, my bike experienced a sudden jolt and immediate loss of propulsion. I was able to pull to the side of the highway to find my front left drive shaft had completely sheared off, the front sproket (currently under recall, which has not yet been replaced according to my dealer's service records) thankfully was caught by the frame underneath or it could have flown out into traffic and hit the other biker behind me or other traffic, or causing me to crash. My drive belt remained fully in tact but was dislodged and dragging, another risk factor for crash. There was absolutely NO warning indicators, lamps, warning lights, messages at all. I definitely felt my life was at risk with this issue. The bike has only 8400 miles on it. Upon additional research online, it shows others have had this same issue and have stated possible casting defects of the drive shaft from the manufacturer. I have the parts currently in my posession, and have an appointment June 26, 2024 with the dealer for inspection.