2018 Can-am Spyder F3
Problems, recalls and owner-reported issues
Power train is the leading concern among 12 owner complaints filed for this model year. This is the highest complaint count among 10 Spyder F3 model years with reports.
What owners report most often
Recalls and investigations
Power train, manual transmission, internal, shaft, outputOct 1, 2024
Bombardier Recreational Products (BRP) is recalling certain 2017-2019 Can-Am Spyder F3 and RT motorcycles. The engine output shaft may fatigue and break, resulting in a loss of drive power.
A loss of drive power increases the risk of a crash.
The output shaft will be replaced based on the mileage of the vehicles. Owner notification letters were mailed February 5, 2025. Owners may contact BRP customer service at 1-888-272-9222.
Campaign 24V728000 on NHTSA.gov
Power train, manual transmissionMay 18, 2022
Bombardier Recreational Products, Inc. (BRP) is recalling certain 2015-2019 Can-Am Spyder F3 and RT motorcycles. The front sprocket may be defective and prematurely wear, resulting in a loss of drive power.
A loss of drive power increases the risk of a crash.
Dealers will perform an interim repair until parts become available. Once parts are available, the front sprocket will be replaced, free of charge. Owner notification letters were mailed May 26, 2022. Owners may contact BRP customer service at 1-888-272-9222.
Campaign 22V352000 on NHTSA.gov
Representative owner complaints: other or unspecified
1 report, newest first. Show all
Other or unspecified, Oct 10, 2022
Shifting / stalling problems: 2018 F3L SE6 **Problem has occurred using each of my 2 Spyder keys Problem definition: At times, bike stalls while driving...begins shaking and remains in last gear prior to the stall. Gear shown in Display does not change from gear it was last in when bike stalled out. Orange exclamation point ! (Vehicle Malfunction) appears on lower left corner of Display and the last gear the bike was in prior to stalling still appears on Display. The gray banner, Transmission Fault also flashed quickly on Display for 2 of the 4 total fault occurrences. This happened when I was traveling in higher gears, approx. RPM at 3900-4200, as in 3rd, 4th, 5th or 6th gear. It stalls with no power to throttle and loss of shifting. **What I do to clear error – so far: Pull off road, turn bike key off, wait a few minutes, remove / reinsert key. Sometimes had to do the re-start procedure 2-3 times before display error clears. ONLY if Display error is cleared do I have power on the engine. Sometimes can start bike with error still in display, but have NO POWER from throttle to engine. Stalling issues happened to me: 7/31/22, 08/04/22, 08/17/22. Dealer duplicated issue - see invoices. BRP Can-Am: had dealer "reprogram"? or update the VCM, and to clean the HCM.