2019 Can-am Spyder RT
Problems, recalls and owner-reported issues
Service brakes is the leading concern among 6 owner complaints filed for this model year. This is the 5th highest complaint count among 10 Spyder RT model years with reports.
What owners report most often
Recalls and investigations
Power train, manual transmission, internal, shaft, outputOct 1, 2024
Bombardier Recreational Products (BRP) is recalling certain 2017-2019 Can-Am Spyder F3 and RT motorcycles. The engine output shaft may fatigue and break, resulting in a loss of drive power.
A loss of drive power increases the risk of a crash.
The output shaft will be replaced based on the mileage of the vehicles. Owner notification letters were mailed February 5, 2025. Owners may contact BRP customer service at 1-888-272-9222.
Campaign 24V728000 on NHTSA.gov
Power train, manual transmissionMay 18, 2022
Bombardier Recreational Products, Inc. (BRP) is recalling certain 2015-2019 Can-Am Spyder F3 and RT motorcycles. The front sprocket may be defective and prematurely wear, resulting in a loss of drive power.
A loss of drive power increases the risk of a crash.
Dealers will perform an interim repair until parts become available. Once parts are available, the front sprocket will be replaced, free of charge. Owner notification letters were mailed May 26, 2022. Owners may contact BRP customer service at 1-888-272-9222.
Campaign 22V352000 on NHTSA.gov
Representative owner complaints: electrical system
1 report, newest first. Show all
Electrical system, Service brakes, Jul 11, 2020
THE ELECTRONIC PARKING BRAKE MALFUNCTIONS AND FAILED TO EITHER ENGAGE OR DISENGAGE. FAILURE TO ENGAGE PREVENTS THE VEHICLE FROM ROLLING AFTER STARTING AND IN GEAR. FAILURE TO ENGAGE ALLOWS THE VEHICLE TO ROLL AFTER STOPPING, TURNING THE ENGINE OFF, AND RELEASING THE MANUAL FOOT BRAKE. IN ORDER TO STABILIZE THE VEHICLE FROM MOVING IF THE EBRAKE WILL NOT ENGAGE, THE RIDER MUST RELEASE THE MANUAL FOOT BRAKE, WHILE ATTEMPTING TO PREVENT THE VEHICLE FROM ROLLING, AND PLACE A CHOCK UNDER TIRE(S). IN ORDER TO PREVENT THE RIDER FROM BEING STRANDED IF THE EBRAKE FAILS TO DISENGAGE, THE RIDER MUST STABILIZE THE VEHICLE FIRST, MANUALLY REMOVE THE REAR BRAKE SPRING, AND LOOSEN THE BRAKE CABLE NUTS TO RELEASE BRAKE CABLE TENSION. THIS REQUIRES A SPRING TOOL AND TWO 12MM WRENCHES. WHILE THIS WILL ALLOW THE RIDER TO NOT BE STRANDED, IT CREATES A HAZARD WHEN THE RIDER ARRIVES AT THEIR DESTINATION AND MUST PARK THE VEHICLE.