2020 Can-am Spyder RT
Problems, recalls and owner-reported issues
Exterior lighting is the leading concern among 6 owner complaints filed for this model year. This is the 4th highest complaint count among 10 Spyder RT model years with reports.
1 person was injured.
What owners report most often
Recalls and investigations
Exterior lighting, brake lightsMar 17, 2023
Bombardier Recreational Products, Inc. (BRP) is recalling certain 2020-2023 Spyder RT and 2022-2023 Ryker motorcycles. The brake lights may stay illuminated even if the brake pedal is not pressed. As such, these motorcycles fail to comply with Federal Motor Vehicle Safety Standard number 108, "Lamps, Reflective Devices, and associated Equipment."
Brake lights that remain illuminated can fail to alert other motorists of the rider's intention and increase the risk of a crash.
Depending on the model, dealers will replace the brake light switch, adjust the brake light switch, and/or add a spring to the brake light switch, as necessary, free of charge. Owner notification letters were mailed March 17, 2023. Owners may contact BRP Customer Service at 1-888-272-9222. BRP's number for this recall is 2023-6.
Campaign 23V175000 on NHTSA.gov
Service brakes, hydraulic, pedals and linkagesMar 27, 2020
Bombardier Recreational Products Inc. (BRP) is recalling certain 2020 Can-Am Spyder RT motorcycles. During emergency braking situations, the support which holds the brake mechanism could break, causing a total loss of braking ability.
A loss of braking ability can increase the risk of a crash.
BRP will notify owners, and dealers will install a reinforcement bracket, free of charge. The recall began April 1, 2020. Owners may contact BRP customer service at 1-888-272-9222. BRP's number for this campaign is Bulletin 2020-5.
Campaign 20V186000 on NHTSA.gov
Representative owner complaints: service brakes
1 report, newest first. Show all
Service brakes, Sep 8, 2022
The Spyder brake switch started failing with less than 14K miles on the vehicle. The driver my wife, did not know it was failing, only an engine code VSS would appear and the vehicle would go into limp home mode, until it could be restarted. Checking online forms, there were several post about the brake switch. I check in our garage and discovered I could push the brake pedal and sometimes there would be a two second delay before the lights would come on. Pressing harder on the brakes made them flicker on and off. At times only half the brake lights would come on. The brake switch is located four inches off the pavement and exposed to road grime. The piston only has an O-ring and lacks a rubber boot to keep debris from entering the switch. (Like my Harley Davidson motorcycle has.) The brake switch part # 710005480 is about $45 and an two hours labor to install. The new replacement switch is #710008326, but it looks just like the switch I took off the Can Am Spyder. Some of my research showed that this brake switch has been used on most if not all Spyders and Ryker motorcycles produced by Can Am in the last few years. I did post this issue on a Spyder Facebook group and within 24 hours eight people stated they had the same issue with their new Spyder, which was repaired under warranty. I just believe it's a bad design for an exposed part four inches off the pavement. Also my wife stepping on the brakes and the brake lights not working for two seconds put her in danger of being struck by another vehicle.