2016 Mazda MAZDA3
Problems, recalls and owner-reported issues
Electrical system is the leading concern among 103 owner complaints filed for this model year. This is the 13th highest complaint count among 22 MAZDA3 model years with reports.
Of the 2016 reports, 7 involved a crash and 1 involved a fire. 5 people were injured.
What owners report most often
Recalls and investigations
Back over prevention, sensing system, cameraJul 14, 2023
Mazda North American Operations (Mazda) is recalling certain 2014-2018 Mazda3 and 2016-2021 CX-3 vehicles. The rearview camera image may not display properly by showing a flickering or distorted image.
A rearview camera that does not display properly can reduce the driver's rear view, increasing the risk of a crash or injury.
Dealers will inspect and replace the rearview camera, as necessary. In addition, dealers will install a wiring harness fastening seal. All repairs will be performed free of charge. Interim notification letters, notifying owners of the safety risk, were mailed September 13, 2023. Final owner letters for affected models and model years in the states of CT, MA, MD, NJ, NY, PA and VA were mailed August 14, 2024. The remaining owner notification letters will be mailed at a future date, anticipated on or before May 1, 2025. Owners may contact Mazda customer service at 1-800-222-5500, Option 6. Mazda's number for this recall is 6023G.
Campaign 23V487000 on NHTSA.gov
Visibility, windshield wiper/washerApr 4, 2019
Mazda North American Operations (Mazda) is recalling certain 2016-2018 Mazda3 vehicles. A defective windshield wiper relay may cause the windshield wipers to become inoperative, reducing the driver's visibility.
Reduced visibility while driving can increase the risk of crash.
Mazda will notify owners, and dealers will replace the front body control module with a new module which uses an improved wiper relay design, free of charge. The recall began May 7, 2019. Owners may contact Mazda customer service at 1-800-222-5500, option 4. Mazda's number for this recall is 3219D.
Campaign 19V272000 on NHTSA.gov
Parking brakeJun 22, 2017
Mazda North American Operations (Mazda) is recalling certain 2014-2015 Mazda6 and 2014-2016 Mazda3 vehicles. Water could possibly enter the brake caliper causing the parking brake actuator shaft to corrode and possibly bind.
If the parking brake actuator shaft binds, the parking brake may not engage or disengage fully. If the parking brake does not engage properly, the vehicle may move unexpectedly if it is parked on a slope, increasing the risk of a crash.
Mazda will notify owners, and dealers will check the parking brake actuator shafts, replacing any that are corroded, free of charge. Remedy parts are currently unavailable. Interim notices informing owners of the safety risk were mailed August 24, 2017. Owners will receive a second notice when remedy parts become available. Owners may contact Mazda customer service at 1-800-222-5500. Mazda's number for this recall is 1217F.
Campaign 17V393000 on NHTSA.gov
Fuel system, gasoline, storageSep 23, 2016
Mazda North American Operations (Mazda) is recalling certain model year 2016 Mazda3 vehicles manufactured September 24, 2015, to October 16, 2015. During manufacturing, the fuel tanks for the affected vehicles may have deformed, resulting in a fuel leak from the recirculation pipe welded connection.
A fuel leak in the presence of an ignition source increases the risk of a fire.
Mazda will notify owners, and depending on the tank lot number, dealers will inspect the recirculation pipe weld, replacing the fuel tank, as necessary, free of charge. The recall began November 1, 2016. Owners may contact Mazda customer service at 1-800-222-5500. Mazda's number for this recall is 0216I.
Campaign 16V685000 on NHTSA.gov
Fuel system, gasoline, storage, tank assemblySep 22, 2016
Mazda Motors North American Operations (Mazda) is recalling certain model year 2014-2016 Mazda3 vehicles manufactured January 4, 2014, to September 18, 2015. The fuel tank of the affected vehicles may have been improperly handled during manufacturing and, as a result, the welded attachment of the Inlet Check Valve (ICV) may fail and allow fuel to leak.
A fuel leak in the presence of an ignition source increases the risk of a fire.
Mazda will notify owners, and depending on the tank lot number, dealers will inspect the ICV weld, replacing the fuel tank, as necessary, free of charge. The recall began November 1, 2016. Owners may contact Mazda customer service at 1-800-222-5500. Mazda's number for this recall is 0116I.
Campaign 16V684000 on NHTSA.gov
Fuel system, gasoline, storage, tank assemblyDo not drive until repairedOct 2, 2015
Mazda North American Operations (Mazda) is recalling certain model year 2015-2016 Mazda3 vehicles manufactured May 21, 2015, to August 25, 2015. The affected vehicles are equipped with a fuel tank with a shut-off valve that can allow fuel to enter into the fuel tank emissions systems. If enough fuel enters the emission system it may leak out onto the ground or result in an engine stall.
A fuel leak in the presence of an ignition source increases the risk of a fire. An engine that stalls increases the risk of a crash.
Mazda will notify owners, and dealers will inspect the vehicle's fuel shut-off valve. As needed, the fuel shut-off valve and the affected fuel tank emissions system components will be replaced, free of charge. The recall began on October 20, 2015. Owners are advised not to drive their vehicle until the repairs have been completed. Mazda will provide rental cars until that time. Owners may contact the Mazda Customer Experience Center at 1-800- 222-5500, option #6. Mazda's number for this recall is 8615J.
Campaign 15V621000 on NHTSA.gov
Representative owner complaints: back over prevention
12 reports, newest first. Show all
Back over prevention, Nov 15, 2024
My 2016 Mazda 3 has had a faulty rearview camera, computerized controls, and monitor display screen for over 2 years now. I am not sure if there is a problem with the electrical system because I have lost the ability to turn on the navigation function, the stereo function, and to see the vehicle maintenance information with non-functioning electrical controls and display screen. Sometimes the monitor display would show a blank screen or a fuzzy screen which is a safety hazard especially when I'm driving my vehicle in reverse and could potentially cause an accident. There has been a recall on the rearview camera since July 2023. I have contacted the Mazda dealership multiple times, and they have repeatedly said that the rearview camera parts are still not available. This is unacceptable because it seriously compromises my safety and the safety of others if I cannot safely back up my vehicle when driving due to the faulty rearview camera, computerized controls and monitor display screen. There should also be a recall on the computerized controls and monitor display screen.
Back over prevention, Nov 7, 2024
The contact owns a 2016 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The contact stated that the rearview camera image was distorted or failed to display an image while reversing. The local dealer was contacted. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The failure mileage was approximately 60,000. Parts distribution disconnect.
Electrical system, Visibility/wiper, Back over prevention, Oct 11, 2024
It’s been over a year since recall number 23v-487 was issued Need to get it taken care of
Back over prevention, Oct 1, 2024
The contact owns a 2016 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The contact stated that while in reverse, the digital display screen flickered before going black. The display screen failed to produce a proper image after powering on independently. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The failure mileage was approximately 100,000. VIN tool confirms parts not available.
Back over prevention, Oct 1, 2024
The contact owns a 2016 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The contact stated that while shifted into reverse, the digital display screen flickered before going black and failed to display a proper rearview image. Upon further inspection, the contact noticed that when the A/C was activated, the rearview image was flickering quickly. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The manufacturer was made aware of the failure. The failure mileage was unavailable. VIN tool confirms parts not available.
Back over prevention, Sep 26, 2024
The contact owns a 2016 Mazda Mazda3. The contact stated that the digital screen went blank and was repaired previously under an extended warranty. The contact then received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The contact stated that while in reverse, the digital screen displayed a distorted image. In addition, the failure was occasionally self-corrected after opening and closing the trunk of the vehicle. The local dealer was contacted, but the vehicle was not diagnosed or repaired due to the cost. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The failure mileage was approximately 125,000. VIN tool confirms parts not available.
Electrical system, Back over prevention, Jun 3, 2024
The rear parking assist camera has only worked intermittently since I purchased the car. There is really no pattern to when or why the camera chooses to work or not work, but It seems most affected by opening and closing the rear hatch: if it's working and i open the hatch, it stops working; if it's not working, opening/closing it will often cause it to work again. This is a problem because parking/backing up becomes a challenge when it's not working. This puts my safety at risk because it increases the chances of me having a fender bender when in reverse.
Back over prevention, May 30, 2024
The contact owns a 2016 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The local dealer was not contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
Back over prevention, Apr 9, 2024
The contact owns a 2016 Mazda Mazda3. The contact stated while reversing, the back-over prevention camera, began to flicker, flashed, and became inoperable. There were no warning lights illuminated. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The failure mileage was approximately 20,000. VIN tool confirms parts not available.
Electrical system, Back over prevention, Mar 1, 2024
A distorted or flickering rearview camera image while reversing could affect driver judgment, increasing the risk of a crash
Lane departure, Back over prevention, Jan 7, 2024
Manufacturer Recall No 6023G NHTSA Recall No. 23V-487 Rear View Camera has NOT been repaired. How long more do I have to wait for the repairs to start? It has been over 6 months since the recall notice went out but I have had the issue for years now. Please step in and make Mazda make good on their products. I have called several dealerships but they all tell me that only Mazda headquarters knows when the repairs kits will become available. So, when is that? Do we wait until more accidents happen so the lawsuits increase over this matter? Last time I checked they are still putting out thousands of cars on the road...does that mean they are too busy to take care of these issues since, after all, they have already pocketed our monies and now we are pushed to the side as if we don't matter? I await great news.
Back over prevention, Oct 13, 2023
The contact owns a 2016 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention) however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. Parts distribution disconnect.